Publicité
Les langues disponibles
Les langues disponibles
At this position fire up the pilot (6). After firing up the pilot keep pressure on the botton
at least 10 seconds to make sure the thermocupul is heated up.
You can adjust the flames to the reuired level by toggling "
If the device is operated for the first time, keep the button pressed at pilot burner flame
position for a while before ignition to discharge the air in the gas installation.
Top surface temerature should be smaller than K80
TURNING OFF
Turn the button (6) to position "
To fully turn the device off, get the indicator to "0" sign.
MAINTENANCE
Never perform maintenance without closing the main gas valve of the device.
Before it cools down completely, wipe the device with a cloth immersed in warm soapy
water.
Do not use cleaning substances and tools that may cause scratches on device surface.
If required, use chemical cleaners.
Do not clean the device with pressurized water or vapour.
If the device will not be used for a long time, coat the surfaces with a thin layer of
Vaseline.
ATTENTION: Any part replacement that may affect safety must be carried out by the
authorized people. During maintenance and repair, keep the main gas valve closed and keep
away fire. Always perform leakage check after repair or part replacement; use foam or gas
detector for this aim. In case of any dangerous condition with the device, notify to the authorized
service. Do not allow unauthorized people to interfere in the device.
DANGEROUS: Never allow leakage check to be performed with flame.
" .Then it will be just the pilot flame is lit
6
" or "
" signs
Publicité
