ARDES AR5S41PB Mode D'emploi page 13

(see image at last page)
1. Front grille
2. Lock ring of the fan
3. Safety screw of the fan
4. Fan
5. Lock ring of the back grille
6. Back grille
7. Motor shaft
8. Oscillation knob
9. Motor
10. Control panel
11. Main body screw
INSTRUCTIONS FOR USE
Place the fan on a flat, dry and stable surface, and insert the plug of the
fan in a socket. Select the desired speed by pressing the buttons on the
control panel (10):
0 = off 1 = minimum speed 2 = medium speed 3 = maximum speed
OSCILLATION:
For the automatic oscillation from right to left press the knob (8) placed
on top of the motor. To disable it, pull up the knob.
VERTICAL SLOPE:
You can vertically point the front of the fan
choosing the desired angle. It is sufficient
to move the front of the fan up or down
according to the desired slope.
ADJUSTMENT HEIGHT
Loosen the height adjustment knob (14),
then set the desired height for the fan. Tighten firmly the knob after
adjusting the rod.
N.B: this operation must always be carried out while the fan is
turned off.
ASSEMBLING
12. Small decorative base
13. Adjustment rod
14. Height adjustment knob
15. Base rod
16. Screws for fixing the base rod
(4 pieces)
17. Plastic base
18. Weight of the plastic base
19. Nuts for weight fixing
20. Lock ring
A-B. Locking pin for the rear grille
13