Publicité
Les langues disponibles
Les langues disponibles
us_main.book.book Page 11 Friday, March 6, 2020 10:25 AM
Dimensions and Clearances
F
G
13/64'' (0.5 cm)
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
CAUTION
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
* This feature is only available on some models.
1
Lift the washer off the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic drum support
comes off with the base and is not stuck to
the bottom of the washer.
• If you must lay the washer down to remove
the carton base
b
of the washer and lay it carefully on its side.
Do not lay the washer on its front or back.
*
2
Remove the bolt assemblies.
• Starting with the bottom two shipping bolts
, use the included wrench to fully loosen
c
all 4 shipping bolts by turning them
counterclockwise.
24'' (60 cm)
*
a
, always protect the side
• Remove the bolt assemblies (bolts and
retainers) by wiggling them slightly while
pulling them out.
3
Install the hole caps.
• Locate the hole caps
accessory pack or attached to the back of
the washer. Install the caps in the holes left
by the bolt assemblies.
CAUTION
• Once removed, save the bolt assemblies for
future use. To prevent damage to internal
components, do not transport the washer
without reinstalling the shipping bolts. Failure to
remove shipping bolts and retainers may cause
severe vibration and noise, which can lead to
permanent damage to the washer.
NOTE
• The power cord is secured to the back of the
washer with a shipping bolt to help prevent
operation with shipping bolts in place.
Connecting the Water Inlet
Hoses
To avoid the risk of costly water damage, purchase
and install new water inlet hoses when installing
the washer.
INSTALLATION
11
included in the
d
Publicité
