Maintenance; Inspection And Maintenance - Husqvarna 115iL Manuel D'utilisation

Inspection and maintenance

WARNING! Always disconnect the
!
battery before any maintenace on the
machine. Carry the hedge trimmer by the
handle with the cutter blade stopped.
IMPORTANT! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
All servicing and repair work on the machine requires
special training. This is especially true of the machine's
safety equipment. If your machine fails any of the checks
described below you must contact your service agent.
When you buy any of our products we guarantee the
availability of professional repairs and service. If the
retailer who sells your machine is not a servicing dealer,
ask him for the address of your nearest service agent.
Only use original spare parts. (Figure 31)
Regularly check that the battery charger and the battery
are intact. (Figure 4)
Cleaning
Clean the machine after use.
To avoid unbalance and vibrations in handles trimmer
head need to be cleaned regulary. In addition, check other
part of the head and the shaft if needed to be cleaned.
Make sure the battery and battery charger are clean and
that the terminals on the battery and the battery charger
are always clean and dry before the battery is placed in
the battery charger. Keep the battery guide tracks clean.
Clean plastic parts with a clean and dry cloth. (Figure 34)
(Figure 23)
Shaft adjustment (telescope)
The lever on the shaft for locking the shaft can be
adjusted.
• Use the Allen key to tighten the screw that holds the
shaft adjustment. (Figure 26)
Trimmer line
Only use the recommended trimmer heads and trimmer
lines. These have been tested by the manufacturer to suit
a particular motor size. This is especially important when
a fully automatic trimmer head is used. Only use the
recommended cutting attachment. See the chapter on
Technical data.
Trimmer head
Check that the trimmer head is undamaged and not
cracked. Replace the trimmer head if necessary. (Figure
24)
• Pull out the line chute assembly.
• Replace the trimmer head.
• Fit the trimmer head.

MAINTENANCE

Replace the trimmer head.
• Insert the locking pin (C) in the hole to lock the shaft.
(Figure 33)
• Screw the trimmer head counterclockwise.
• Fit the trimmer head.
–
English 17