Campingaz Fargo Serie Utilisation Et Entretien page 10

Flexible tubing connection: To connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
GB
provided:
- no. 11 wrench to tighten the connector
- no. 17 wrench to tighten the nut on the tubing
Fargo
11
f) Checking for gas leaks
1) Work outside, away from all sources of ignition. Do not
smoke.
2) Make sure the control knob is in the "off" (O) position.
3) Push the end of the hose completely onto the regulator
nozzle and secure with a suitable clip.
4) Fit the regulator onto the gas cylinder in accordance
with its instructions.
5) Use a gas leak solution to test for leaks. Important:
never use a naked flame to check for gas leaks.
6) Apply the solution to the connections cylinder/regulator/
hose/apparatus (the control knobs should remain
closed: off position). Open the gas cylinder valve.
7) Bubbles in the gas leak solution indicate that there are
gas leaks.
8) The leak can be stopped by tightening any hose
connection or replacing any faulty component. The
barbecue must not be used until the leak is stopped.
9) Close the valve on the gas cylinder. Check for leaks at
least once per year and each time the gas cylinder is
replaced.
g) Prior to use
Never use the barbecue until the instructions have been
read carefully and understood. Also, make certain that:
- there are no leaks
- the venturi tubes are not blocked
- the hose does not touch any components which may get hot.
- that the feet are unfold (see paragraph K) 2.).
h) Lighting the burner
Read steps 1 to 5 before beginning with step 1.
1) Make sure the control knob is in the "off" (O) position.
All manuals and user guides at all-guides.com
O
10
2) Open the gas cylinder valve.
3) Press the control knob and turn it to the full flame
( ) position, then immediately press the igniter
button ( ) until you hear the click. Repeat 3 or 4
times if necessary until the burner is lit.
4) If the burner fails to light, turn the control knob to the
"off" position (O). Wait 5 minutes before repeating the
operation.
Important:
If the burner fails to light after the 2 nd attempt, turn the
control knob to the "off" position (O) and check that the
burner outlets and the venturi tube are not blocked.
burner outlets
i) Lighting manually the burner
If Piezo ignition does not work, put the adjustment lever
in the "OFF" (O) position. Remove the drippings tray
located under the vat. Hold a lighted match to the
opening located under the burner, then open the lever on
the control panel to full-flow position ( ). Reposition the
drippings tray.
j) Turning off the grill burner
Return the control knobs to the "off" position (O), then
close the cylinder valve.
k) Operation
1. It's recommended that protective gloves be worn to
handle components which may be very hot.
2. Before start-up, put the feet in place (see paragraph c),
then open the fold-down shelves:
Ì Unfold the two shelf-support wires.
Ì Open the shelves until they are resting on the shelf-
support wires.
burner tube