Danby Silhouette DFF9102BLP Manuel D'utilisation page 7

Frequently, a problem is minor and a service call may not be necessary, use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll
Free Number for assistance.
Difficulty
Does not work
Refrigerator running
too frequently
Internal temperature
too cold
Internal temperature
not cold enough
Freezer is not cold
enough
Light will not work
Care and Maintenance
Possible Cause
No power to unit.
Power cord is unplugged.
Wrong voltage is being used.
Temperature control too high.
Door is not closed.
Hot food inserted.
Doors opened too long
or too often.
Close proximity to heat source
or direct sunlight.
Temperature control too high.
No power to unit.
Power cord is unplugged.
Temperature control too low.
Door is not closed.
Hot food inserted.
Doors opened too long
or too often.
Air flow obstruction.
Wrong voltage is being used.
Close proximity to heat source
or direct sunlight.
Temperature control too low.
Door not closed.
Hot food is inserted.
Door opened too long
or too often.
Wrong voltage is being used.
No power to unit.
Power cord is unplugged.
Bulb is loose, needs replacing
or the door switch is stuck.
Suggested Solution
Check connection of power cord at
power source.
Plug in unit.
Use proper voltage.
Check setting and adjust as needed.
Close door securely.
Be sure that food is cool before inserting.
DO NOT keep door open for too long.
MINIMIZE door openings.
DO NOT place unit close to heat sources
or direct sunlight.
Check setting and adjust as needed.
Check connection of power cord at
power source.
Plug in unit.
Check setting and adjust as needed.
Close door securely.
Be sure that food is cool before inserting.
DO NOT keep door open for too long.
MINIMIZE door openings.
Allow room for air to circulate around unit.
Use proper voltage.
DO NOT place unit close to heat sources
or direct sunlight.
Check setting and adjust as needed.
Close door securely.
Be sure that food is cool before inserting.
DO NOT keep door open for too long.
Use proper voltage.
Check connection of power cord to
power source.
Plug in unit.
Tighten or replace the bulb. Check the
switch for obstructions and clean.
5