Danby Silhouette DFF9102BLP Manuel D'utilisation page 5

Door Reversal Instructions
CAUTION: To avoid personal injury to yourself
and/or property, we recommend someone assist
you during the door reversal process.
1. To access the lower hinge assembly, tilt back the
refrigerator cabinet or lay the refrigerator on
its back. (Fig. A)
2. Remove both leveling legs located at the front of
the cabinet.
3. Remove the screws holding the lower hinge
assembly to the cabinet. (Fig. A)
4. Remove the main door assembly from the
refrigerator cabinet. (open door and pull down)
5. Remove the screws from the middle hinge
assembly. Then remove the hinge and freezer
door. (Fig. B)
6. Remove (unscrew) the top hinge pin. (Fig. C)
7. Re-install the main door top hinge pin on the
opposite side of the cabinet. (Fig. C)
8. Remove the door plug and door bushing located
on the top and bottom of each door assembly.
9. Interchange positions. (ie. door plug right side,
door bushing left side.)
10. Re-install freezer door assembly on cabinet.
11. Re-install the middle hinge assembly on the
opposite side.
12. Make sure the door assembly is properly aligned
on the cabinet, before tightening hinge screws.
13. Re-install main door assembly on cabinet.
14. Re-install the lower hinge assembly on the
opposite side. Making sure to change bushing
and screw on opposite sides on bottom of unit
15. Make sure the door assembly is properly
aligned on the cabinet, before tightening
lower hinge screws.
16. Re-install both leveling legs.
The process is now complete.
Fig. A
Fig. B
Fig. C
Light Bulb Replacement
To replace the refrigerator light bulb:
1. Remove the screw from the light bulb cover.
2. Pull the light bulb cover downward.
3. Unscrew the bulb.
4. Replace with a standard 40 watt appliance bulb only.
3