Publicité
Les langues disponibles
Les langues disponibles
Never use the garden tool when the safety
equipment is defective, without cover or without
protective equipment such as the bumper and/or the
collection box.
Do not start the electric motor when the ejection
channel is not
not covered by the discharge flap or the grass
catcher.
Never open the ejection flap and/or never put
down the grass catcher while the blade is moving.
The spinning blade can cause serious injury.
Regularly check the entire device and the
collection box, in particular
before storing it (before wintering for example) to
check that it is not
worn or damaged. Replace worn or damaged parts
immediately to ensure safe operation at all times.
If the grass catcher is full, the airflow stops. This
is an indication to empty the grass catcher.
When transporting, remove the grass catcher.
> Emptying the grass catcher
For safety reasons, stop the
electric motor before
to put down the collection box.
● Open the rear cover and remove the grass
catcher by holding the handle.
● Empty the grass catcher
SETTING THE CUTTING HEIGHTS
«
Fig C »
Adjust the cutting height
only when the engine is
switched off and the power
Before you begin to mow, check to ensure that the
blade is not blunt and that none of the fasteners are
damaged. To prevent any imbalance, replace blunt
and/or damaged blades. To carry out this check,
first switch off the motor and pull out the power plug.
To obtain the desired cutting height, the front and
rear axles are repositioned on the underside
of the mower housing.
Disconnect the mower from
the power supply and
ensure the blade has
stopped coasting before
adjusting the height.
Risk of injury!
Important!
cable has been
disconnected.
Warning!
1. To raise the height of the blade, grasp the height
adjustment lever and move it towards the rear of the
mower.(2c)
2. To lower the blade height, grasp the height
adjustment lever and move it toward the front of the
mower. .(2c)
> 5 Cutting height positions
25mm, 39mm, 52mm, 66mm, 80mm
§ 25 mm (lowest cutting height position)
~
§ 80 mm (highest cutting height position)
OPERATION «
> Connect to power supply.
Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Connect the plug to an extension cable. It is
imperative to secure the extension cable with the
cable grip.
«
> Starting
Fig D »
Press and hold safety button (A) (then squeeze the
switch lever (B) towards the handle).
Release the safety button.
> Stopping
Release the switch lever.
After switching off, the
cutting blade will go on
turning for a few seconds,
make sure the blade has
Do not rapidly switch off
> Safety button
Important! To prevent the machine switching on
accidentally, the lawn mower is equipped with
a safety lock-off which must be pressed before the
switching bar can be activated. The lawn mower
switches itself off when the switch is released.
Repeat this process several times so that you are
sure that the machine functions properly.
Before you perform any repair or maintenance work
on the machine, ensure that the blade is not rotating
and that the power supply is disconnected.
Fig B & D »
«
Fig B »
ATTENTION :
come to a complete
standstill.
CAUTION:
and on.
37
Publicité
