Publicité
Les langues disponibles
Les langues disponibles
9
Troubleshooting
Do not repair or disassemble the air conditioning by yourself. Unqualified repair will lead to failure of
the warranty card, and may cause damage to users or their properties.
Problems
The air
conditioning does
not work.
The cooling effect
is not good
Big noise
Compressor does
not work.
Local air conditioner / User Manuel
Reasons
There is no electricity.
The overflow indicator "
The ambient temperature is too low
or too high
In cooling mode, the room
temperature is lower than the set
temperature;
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed on
a flat surface.
Overheat protection starts.
Solutions
Turn it on after connecting it to a
socket with electricity.
" will flesh . Discharge the water inside.
Recommend to use the machine in at
the temperature of 7-35°C (44-95°F).
Change the set temperature.
The machine is placed in a room with
an ambient temperature of greater
than 17°C (62°F).
Pull the Curtain.
Close doors and windows, and add
new air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and
hard place (to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and then
restart the machine.
33 / 76 EN
Publicité
