Before Use - Metabo HPT WH 18DSDL Instructions De Sécurité Et Mode D'emploi

English
● If the battery is rechraged when it is warm due
to battery use or exposure to sunlight, the pilot
lamp may light in green.
The battery will not be recharged. In such a case,
let the battery cool before charging.
● When the pilot lamp fl ickers rapidly in red (at
0.2–second intervals), check for and take out
any foreign objects in the charger's battery
installation hole. If there are no foreign objects,
it is probable that the battery or charger is
malfunctioning. Take it to your authorized
Service Center.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Installing the bit (WH18DSDL)
Always follow the following procedure to install driver
bit. (Fig. 6)
Guide sleeve
Driver bit Hexagonal hole
in the anvil
(1) Pull the guide sleeve forward.
(2) Insert the bit into the hexagonal hole in the anvil.
(3) Release the guide sleeve and it returns to its origianl
position.
CAUTION
If the guide sleeve does not return to its original
position, then the bit is not installed properly.
2. Removing the bit (WH18DSDL)
Please do the opposite point on the method of
installing bit.
3. Selecting the socket matched to the bolt (WR18DSDL)
Be sure to use a socket which is matched to the bolt
to be tightened. Using an improper socket will not only
result in insuffi cient tightening but also in damage to
the socket or nut.
A worn or deformed hex. or square-holed socket will
not give an adequate tightness for fi tting to the nut
or anvil, consequently resulting in loss of tightening
torque.
12
Movement
Fig. 6
Pay attention to wear of socket hole, and replace
before further wear has developed.
4. Installing a socket (WR18DSDL)
Select the socket to be used.
● Plunger type (Fig. 7)
Align the plunger located in the square part of the
anvil with the hole in the hex. socket. Then push
the plunger, and mount the hex. socket on the anvil.
Check that the plunger is fully engaged in the hole.
When removing the socket, reverse the sequence.
CAUTION
● Please use the
which are listed in the operations manual and
metabo HPT's catalog. Accidents or injuries
could result from not doing so.
● Make sure to fi rmly install the socket in the anvil.
If the socket is not fi rmly installed it might come
out and cause injuries.
Hexagonal socket
5. Confi rm that the battery is mounted correctly.
6. Check the rotational direction
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the push button.
The L-side of the push button is pushed to turn the bit
counterclockwise. (See Fig. 8).
(The and marks are engraved on the body.)
R
Push
Trigger switch
designated attachments
Groove
Anvil
Fig. 7
L
Push
Push button
Fig. 8