Pattfield Ergo Tools PE-20 HDB Traduction De La Notice Originale page 66

ATTACH BATTERY
1 Slide the battery 7 (not included) onto
the drill driver until it clicks into place.
Caution! Only use the batteries
specified in technical data.
FIT BIT
1 Open the chuck ring 1 until the bit fits
into the chuck.
Caution! Before changing bits, cen-
tre the rotation direction switch, in
order to lock the drill driver.
FIT DRILL
1 Open the chuck ring 1 until the drill fits
into the chuck.
Caution! Before changing drills,
centre the rotation direction switch,
in order to lock the drill driver.
DRILL FUNCTION
1 Set the function ring to when drilling
in wood, metal or plastic.
Caution! Make sure the tool is
switched off.
ROTATION DIRECTION
1 To drive in screws or drill, set the rota-
tion direction switch 9 to
.
Caution! Wait until the chuck has
stopped rotating before changing
the rotation direction.
Adjustments
130 EN
2 To release the battery, press the bat-
tery release switch 6 and slide off the
battery.
2 Fit the bit into the chuck 2 and tighten
the chuck ring 1 securely. Set the de-
sired torque at the torque ring 10.
Remove the bit by opening the chuck
ring 1.
2 Fit the drill into the chuck 2 and tight-
1
en the chuck ring securely. Set the
torque ring 10 to drill .
Remove the drill by opening the chuck
ring 1.
HAMMER DRILL FUNCTION
2 Set the torque ring 10 to impact drilling
when drilling in masonry and con-
crete.
2 To loosen screws, set the rotation di-
rection switch 9 to
.
1
1
1
1
1
2
1.
2.
2
2
2
2