Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
5
6
1
11
10
2
Product overview
1
Chuck ring
2
Chuck
3
On / Off switch
4
Soft grip
5
LED light
6
Battery release switch
7
Battery (not included)
8
Belt clip
9
Rotation direction switch
10
Torque ring
11
Gear selector
9
Intended Use
The tool is intended for driving in and loos-
ening screws as well as for drilling in wood,
metal and plastic.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Battery power
8
5
The LED light
flashes if the battery power is
running low.
7
CHARGE BATTERY
1
Plug the charger (not included) into a
suitable wall socket.
Caution! Only use the battery
charger specified in technical data
to charge the battery.
Using the tool
1. Set the desired rotation speed on the gear
selector 11.
1
gear
Screw driving /
st
Larger diameter drilling
2
gear
nd
Smaller diameter drilling
2. To switch on the tool, press the on / off
switch 3. The more the on / off
switch 3
pressed, the faster the drill driver rotates.
3. Make sure your workpiece can not slip.
Start working while holding the tool firm-
ly.
4. To switch off the tool, release the on / off
switch 3.
Warning! If the drill driver is not in
use, centre the rotation direction
switch, in order to lock the drill driver.
Overload protection
When the load is too high or the allowable
battery temperature is exceeded, the mo-
tor comes to a stop. Relieve the load on the
machine immediately and allow cooling for
approx. 30 seconds at the highest no-load
speed.
2
Slide the battery (not included) onto
the charger and check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery defective
Flashing Green: Battery too hot/ cold
EN
is
129
Publicité
