Tripp-Lite ECO350UPS Manuel De L'utilisateur page 5

Quick Installation
STEP 1: Plug the UPS into
a properly grounded outlet.
After plugging the UPS into a wall outlet, the surge
only outlets will begin passing power.
Note: The UPS will not turn on automatically in the
presence of live utility power.
STEP 2: Plug your equipment
into the UPS.
There are two sets of outlets on your UPS. Outlets
marked SURGE ONLY /
backup power during power outages. Connect
common desktop items like printers, scanners and
other accessories not requiring battery support to
these outlets. Outlets marked BATTERY BACKUP /
offer UPS battery backup support during power
failures. Connect your vital computer equipment
into these outlets.
Your UPS is designed to support electronic
equipment only. You will overload the UPS if the
total volt-amp (VA) ratings for all the equipment
connected to the BATTERY BACKUP /
outlets exceed the UPS output capacity. To
find your equipment's VA ratings, look on their
nameplates. If the equipment is listed in amps
(A), multiply the number of amps by 120 to
determine VA. For example: 1A × 120 =
120VA. If you suspect you have overloaded the
outlets, remove some equipment.
STEP 3: Turn the UPS on.
Press and hold the power switch next to the status
LED or LCD screen until the alarm begins to sound,
then release.
The UPS alarm will sound twice as the battery
backup outlets begin passing power and the UPS
charger engages as necessary to keep batteries
fully charged.
Your UPS is now ready to protect equipment
connected to the battery backup outlets from
blackouts, brownouts, overvoltages and power
failures.
20-08-195-9338D5.indb 5 20-08-195-9338D5.indb 5
(All Models)
do not provide battery
5
9/1/2020 1:28:43 PM 9/1/2020 1:28:43 PM