Publicité
Les langues disponibles
Les langues disponibles
4. CONTROLS
A
B
Button Function
A
Press the button to activate the keyboard and all the
lights come on at half intensity. If the keyboard is
not used for approximately 15/30 seconds it returns
to Stand-by.
Press briefly to turn the motor Off.
B
Activates speed one.
Press and hold the button for approx. 2 seconds to
Activate/Deactivate the motor in 24h Air Circulation
mode, a speed that allows ducting for 10 minutes
every hour, for a 24 hour cycle. Cannot be activated
if Intensive mode is active.
It is also deactivated when the motor is turned Off.
C
Activates speed two.
D
Activates speed three.
E
Activates Intensive speed. This speed is timed to run
for 6 minutes. At the end of this time the system will
automatically return to the speed set before.
It is disabled by pressing the Button or turning the
Motor off.
F
Activates Delay mode, causing automatic shutdown
of the Motor and the Lighting system with a 15
minute delay.
It is disabled by pressing the button.
G
Brief pressure: Light On – Medium Light – Light Off. -
To change the temperature of the light in cycle, make
long, separate presses on the button. This allows
variation of the light tone from "warm" to "cool".
H
With the filter alarm triggered, press the button to Reset
the alarm. All the Leds will flash 3 times.
Press and hold the button for approximately 2 seconds,
with all the loads turned off (Motor and Lights), to turn
the Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 2
seconds.
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
10
C
D
E
F
Led
-
-
On/Off
Flashing
On/Off
On/Off
Flashing
On/Off
-
When the procedure terminates, the indication
shown previously turns off:
C+H Flashing
Indicates that it is necessary to wash the metal
grease filters. The alarm is triggered after the
Hood has been operating for 100 working hours.
D+H Flashing
Indicates that it is necessary to change the
activated charcoal filters and wash the metal
grease filters at the same time. The alarm is
triggered after the Hood has been operating for
200 working hours.
All the Leds flash 2 times.
All the Leds flash 1 times.
G
H
Publicité
