Publicité
Les langues disponibles
Les langues disponibles
•
picture, audio and video recording
•
comes with USB cable
5.
Overview
Refer to the illustration on page 2 of this manual.
A mini-SD card slot
B on/off switch
C microphone
D camera lens
E selection switch
6.
Operation
•
Slide a micro SD card (not incl.) in the micro SD slot [A], see the markings on the
housing for correct way. The recorder does not work without a card.
•
Switch the camera on by moving the on/off switch [B] to the on-position (up). Now,
hold the record/stop button [I] pressed until the power LED [G] turns on. Depending
on the position of the selection switch [E], either the video recorder status LED [H]
turns blue or the picture recorder status LED [F] turns red.
•
Switch the selection switch [E] to VIDEO (down) to record video.
•
Press the record/stop button [I] shortly to start recording. The video recorder
status LED [H] blinks.
•
Press the record/stop button [I] shortly again to stop recording. The video recorder
status LED [H] turns blue again.
Note: Always stop the recording first before switching off the recorder or switching to
picture recording, otherwise the data of the last recording session is lost.
•
Switch the selection switch [E] to PHOTO (up) to record pictures.
•
Press the record/stop button [I] shortly to take a picture. The picture recorder
status LED [F] briefly turns off.
•
Press and hold the record/stop button [I] to start sound recording. The picture
recorder status LED [F] starts blinking. Press the record/stop button [I] again to
stop recording sound.
•
Data is recorded in AVI video format and JPG image format. Sound is recorded in WAV
format. Free conversion software is available on the internet.
•
To play back recorded files, set the on/off switch [B] to "off" and the selection switch
[E] to "video". Connect the included USB cable to the USB port [J] and the other end
to the USB port of a suitable computer. When connected, the recorder acts as a
removable disk; data can be copied, played back or deleted.
Note: remember to stop the device the appropriate way before disconnecting from the
USB port.
•
To charge the internal battery of the recorder, connect it with a powered USB port
using the included USB cable.
19/07/2010
CAMCOLVC7
F picture/sound recorder status LED
G power LED
H video recorder status LED
I
record/stop button
J USB connection
4
Rev.02
©Velleman nv
Publicité
