Publicité
Les langues disponibles
Les langues disponibles
The Controls of your
Wine Cooler
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. '
' Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. '
' Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controled by the reed
swith, and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
Setting the
Temperature
When you plug in your wine
cooler for the first time,
the temperatures will auto-
matically be set to 54°F
(12°C) in the upper zone and
to 45°F(7°C) in the lower zone,
and will be displayed in the
Fahrenheit scale (°F)
Function
Instructions
NOTE !
If too many bottles are put in at
once or the door has not been
closed tightly, the unit will display the
"HI" signal in the display panel. This
is normal please wait 5 minutes
after you close the door and
"HI" will disappear.
It is normal that the unit
shows "HI" or "LO" from time to time,
If it occurs frequently or lasts for a
long time, you can restart the unit by
unplugging it. If the problem
occurs once again after restart,
please contact customer service.
Operating Instructions
5. '
' Window
For viewing the temperature
of the upper zone.
6. '
' Window
For viewing the temperature
of the lower zone.
The temperature range can
be set as low as 39°F (4°C)
or as high as 64°F (18°C) to
suit your specific storage
requirements. Each depres-
sion of the
or
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
mentioned range.
Temperature Memory Function
In the event of a power interruption the unit can remember the
previous temperature settings, and when the power is restored the
cabinet temperature will go back to the same setting temperature as
before.
Door Ajar Alarm Function
If the door is not closed completely the alarm will sound after 5 minutes.
Please close the door completely to avoid the loss of cold energy.
Temperature Alarm Function
If the inner temperature is higher than 73°F(23°C), "HI" is shown
in the display panel, or if and the alarm will sound after one hour.
If the inner temperature is lower than 32°F(0°C),"LO" is shown in
the display panel and the alarm will sound. Refer to the trouble
shooting guide on page 11 for more information.
6
°
°
°
°
6
' Button
7. '
Used to set the temperature in
the upper zone (see 'Setting the
Temperature' below).
' Button
'
Used to set the temperature in
the lower zone (see 'Setting the
Temperature' below).
To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the
control buttons simultaneo-
but-
usly for approximately
five(5) seconds.
7
and
Publicité
