Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Attention: always unplug the appliance before you assemble to the fan.
To assemble it, refer to figures: first place the front shell (D) on the body, plug
the power cord through the guidance of the rear shell (F), couple the rear shell to
the front (align the four holes "E") secure the 4 screws (B) provided.
USE
Warning: The fan can only be used if properly assembled in good condition.
The fan functions are operated with both the keypad of the control panel and the
remote control which must be pointed at the front (maximum distance of about
4m) towards the control panel.
To replace the "CR2025" battery, move the tab
to the centre (using a small screwdriver) and
simultaneously remove the battery holder.
Replace the battery (while checking correct
polarity), and close the battery holder. Remove
the battery for long periods of inactivity of the
remote control.
The fan has the following setting and control elements:
Stand-by-ON button "
-
- Ventilation: the three speeds are selected by pressing the "SPEED" (2) button:
the symbol corresponding to the selected speed will light up: (
med;
=max).
" (1): To turn the fan on or turn it off in standby mode
14/40
=min;
=
Publicité
