Abus AirSecure CO2WM110 Manuel D'utilisation page 14

Operating buttons and display symbols
2. When supplied by battery:
When the carbon dioxide level changes to " poor ", the display turns on, the
red LED and the display flash, and the alarm tone sounds for 30 seconds. After
that, the red LED and display continue to light for 1 minute; then the screen
turns off.
The red LED will flash every 5 seconds until the CO
the yellow LED will flash every 5 seconds until the CO
then the green LED will flash every 5 seconds.
3. When "Do Not Disturb" is active:
When the carbon dioxide level changes to " poor ", the display will turn on,
the red LED and the display will flash for 30 seconds. After that, the red LED
and display continue to light for 1 minute; then the screen turns off.
The red LED will flash every 5 seconds until the CO
the yellow LED will flash every 5 seconds until the CO
then the green LED will flash every 5 seconds.
The default time for "Do not disturb" is 22:00 - 08:00.
The time can be adjusted in the settings (see page 28).
4. Temperature and humidity:
When the temperature and humidity values fall below or exceed, there are the
same displays as for the CO content, but without an alarm sound.
2
Default values temperature: min. 19°C, max. 27°C.
Default values humidity: min. 30%, max. 80%.
The default values can be adjusted in the settings (see page 28).
level returns to normal, then
2
level returns to good, and
2
level returns to normal, then
2
level returns to good, and
2
– 26 –
Edit menu settings
1. Switch on the detector, press the "Settings" button
for three seconds
2. Press the "Settings" button
current symbol
3. Move to the left by pressing the
the right by pressing the
4. When the "Back" symbol
"Settings" button
page
Set date and time
1. flashes during setting
2. Decrease the number by pressing the
increase the number by pressing the
3. To exit and save the selected settings, press the
button
4. When the "Back" symbol
"Settings" button
page
Manual language selection
1. flashes during setting
2. Move to the left by pressing the
ES
the right by pressing the
3. To exit and save the selected settings, press the
button and go back to the main settings page
briefly to select the
button and to
button
flashes, briefly press the
to return to the main settings
button and
button
flashes, briefly press the
to return to the main settings
button and to
button
– 27 –
Settings
GB