Intended Use - Abus AirSecure CO2WM110 Manuel D'utilisation

Intended use, Start-up

Intended use

Only use the device for the purpose for which it was built and designed. Any
other use is not considered to be the intended use!
This device may only be used for the following purpose:
· Measuring carbon dioxide content, temperature and humidity in privately
used indoor spaces.
Poor indoor air is considered unhealthy. It can cause drowsiness, lack of
concentration and illness.
Reference values for carbon dioxide
250-350 ppm: normal ambient outdoor concentrations
600 ppm: minimum air quality impairment
600-1000 ppm: high air quality impairment
1000 ppm: indicates insufficient ventilation;
complaints such as headaches, fatigue or irritation of the eyes
and throat can occur.
1000 ppm should be the upper limit for the CO
Start-up
Before using the detector for the first time, please read the following
instructions carefully and observe all warnings, even if you are familiar with
the use of electronic devices.
1. Store and operate the detector in a dry place out of direct sunlight to protect
the components inside the detector
2. Before using the carbon dioxide detector for the first time, set it up in a
well-ventilated environment
3. In order to maintain the best performance of your detector, please use it for
at least 24 hours of permanent operation
4. Do not cover the detector and in particular do not block the air inlets while
concentration in the room.
2
– 20 –
the detector is active
5. Keep water and other liquids away from the detector as it is not waterproof
6. Do not insert sharp, flammable or metallic objects into the air inlets as this
can result in an electric shock or burns
7. Power should be supplied via the micro-USB cable and the AC adapter; the
internal, built-in battery is only used for emergency power supply
8. The detector can be mounted on the wall or set up with the table base
9. If the device has been dropped or otherwise damaged, it may not be used
anymore
10. The device must not be opened or repaired. Failure to comply will invalidate
the warranty
Wall installation:
• mark the drill holes horizontally with the enclosed
template and a spirit level
• drill the holes with a ø 5 mm drill bit. Impor-
tant: do not damage any cables when drilling
and keep the detector away from drilling dust!
• push the plastic dowels into the drilled holes
and screw in the screws until the screw heads
protrude approx. 5 mm
68 mm
Installation
ø 5 mm
– 21 –
GB