2
IGNITE / ON
IGNITE / ON
Main burner
Match light
1.
If the burner will not light after several attempts then the burner can be match lit, before using the match
allow 5 minutes for any accumulated gas to dissipate.
2.
Clip a paper match on one end of the lighting rod.
3.
Light match.
4.
Hold lighting rod and insert lighted match right next to the burner ports or ceramic file.
g
g
5.
Push and turn the designated control knob to IGNITE/HIGH.
6.
Burner should ignite immediately.
OFF
1
g
1
Make sure the lid is open.
Push and slowly turn the Rear Burner knob to IGNITE/ON
2
position. Keep knob pressed in until the burner is lit. Once
it is lit, continue to press and hold for another 15 seconds to
ensure the burner stays lit.
th b
3
If burner does not light within 5 seconds, turn the knob to
OFF position and repeat the lighting procedure.
4
If burner fails to light after step 3, turn the knob to OFF
position, wait 5 minutes, then repeat the lighting procedure
or light by match.
g
Lighting Instructions
t
lit
Rear burner
IGNITER/HIGH
p
continued
OFF
LOW
27