Nexgrill 720-0830D Mode D'emploi page 13

1. Caster Assembly
Mount the casters onto the bottom panel (L) using
sixteen 1/4-in. x 15-mm truss head screws with
locking washers (AA) and sixteen ¼" flat washer locking washers (AA) and sixteen ¼ flat washer
(EE).
The swivel caster with brake (Q) should be
positioned under the left rear of the cart bottom and
the swivel caster (P) should be positioned under
left front as shown in Fig. 1.
The two stationary casters (R ) should be
positioned under the right side.
Note: The gap of the two stationary casters should
be facing the inside bottom panel.
Turn over the bottom panel for assembling casters.
2. Side Panel Assembly
Use three 1/4-in. x 15-mm truss head
screws with locking washers (AA) to
connect the bottom of the left side panel (I)
to the bottom panel (L). Make the left side
panel flush with the rear of bottom panel
and tighten the screws as shown in Fig. 2.
Repeat for the right side panel (H). Repeat for the right side panel (H).
P
16 x EE
16 x AA
6 x AA
L
Assembly Instructions
Fig. 1
Q
R R
Fig. 2
I
L
H
13