ETI 54465141 Guide D'utilisation Et D'entretien page 4

installation (continued)
5
Making the electrical connections
□ Remove the cover of the electrical box attached to the LED plate.
□ Connect the hot and neutral (black and white) wires from the electrical source
to the same color wires from the electrical box attached to the LED plate.
□ Connect the green wire from the electrical source to the ground wire from the
electrical box attached to the LED plate.
□ If a 0-10v dimming circuit is available, connect the purple and gray wires from
the electrical source to the same color wires in the electrical box attached to
the LED plate.
□ If 0-10v dimming is not desired, wrap the ends of the purple and gray wires
with electrical tape to cover the wires.
□ Cover each wire connection with a wire connector (FF) and electrical tape (not
included).
LED Plate
7
Reattaching the LED plate
□ Place the LED plate into the fixture body (B).
□ Twist the two white plastic locks to secure
the LED plate to the fixture body (B).
LED Plate
B
6
Covering the electrical
box
□ Tuck all wire connections into the
electrical box.
□ Snap the electrical box cover back in
place to cover the wire connections.
Electrical Box
Cover
LED Plate
FF
8
Attaching the lens cover
□ Place the lens cover (A) onto the fixture body (B).
□ Close the 10 stainless steel clamps from the fixture body (B) onto the
lens cover (A) to create a vapor tight seal.
Stainless Steel Clips
6
suspension Mounting
noTe: Separate mounting hardware (not included) not shown to actual size.
1
Preparing to mount the fixture
□ Drill two 1/16 in. diameter holes 33 inches apart in the
ceiling to accommodate hook screws (not included).
□ Install the hook screws into the mounting surface,
Electrical Box Cover
making sure to fasten the combo wood-machine end into
the metal hook.
□ Tighten the hook screws (not included) into the studs.
noTe: Eye hooks (not included) or toggle bolts (not
included) can be used as alternate methods of attaching
the fixture to the ceiling.
3
Hanging the fixture
□ Hook the V clip (DD) on each end of the fixture to the metal hooks installed in the ceiling.
noTe: Product should be suspended using metal chain or hooks with weight bearing capacity exceeding 11 lbs (5 KG).
A
B
2
Installing the bracket and clip for
hanging
□ Snap the U bracket (CC) onto the back of the fixture
body (B) near one end.
□ Insert the ends of the V clip (DD) into the openings in the
U bracket (CC).
□ Repeat the installation process for the U bracket (CC) and
V clip (DD) on the other end of the fixture body (B).
A
DD
CC
B
A
7
Please contact 1-855-384-7754 for further assistance.
DD
CC
B
www.ETiSSL.com