ETI 54465141 Guide D'utilisation Et D'entretien page 2

Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Tools/Hardware Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
safety information
WarninG: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so could lead to electric shock, fire,
or other injuries which could be hazardous or even fatal.
WarninG: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker
.
Warranty
This product is warranted for a period of 5 years from the date of original purchase against defects in materials and workmanship. If this
product should fail to operate due to defects in material or workmanship within 60 months of purchase, see www.ETiSSL.com for details.
This product will be repaired or replaced, at ETi's option. This warranty is expressly limited to repair or replacement of product, and liability
for direct, incidental, or consequential damages is hereby expressly excluded. Some states do not allow exclusions of direct, incidental or
consequential damages, so the above limitation of exclusion may not apply to you. This warranty gives the consumer specific legal rights,
which vary from state to state. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.
Hardware Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Suspension Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Surface Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Linking Fixtures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
noTiCe: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WarninG: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
2
pre-installation
PLANNING INSTALLATION
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with the package
contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
noTe: Keep your receipt and these instructions for proof of purchase.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
TOOLS/HARDWARE REQUIRED
Tools and hardware required vary by type of installation.
Wire Safety
Strippers Goggles
Flathead Phillips
Screwdriver Screwdriver
Power Drill Hook
with drill bits Screws*
CaUTion: Chains/cables and hooks must have weight bearing capacity exceeding 11 lbs. (5 KG). S hooks must be ≤ 0.1 in. (2.5 mm).
noTe: Eye hooks can be used as an alternate method of attaching the fixture to the ceiling when suspension mounting.
PACKAGE CONTENTS
A
Part Description Quantity
A Fixture Lens Cover 1
B Fixture Body 1 B
Ladder Gloves
Electrical Wire
Tape Cutters
* For suspension mounting only
3 www.ETiSSL.com
Please contact 1-855-384-7754 for further assistance.