Pattfield Ergo Tools PE-TP 1000 N Traduction De La Notice Originale page 114

When installing, never hang the equipment by the discharge line or
by the power cable. The device must be hung up by the provided sus-
pension eyelets.
The pump shaft should be large enough.
5.2 Mains connection
Danger!
The equipment you have purchased comes with an earthing-pin plug.
The equipment is designed for connection to a socket outlet with
earthing contact for 220-240 V~ 50 Hz. Make sure that the socket-
outlet is suffi ciently fused (at least 6 A) and in good working order.
Insert the power plug in the socket-outlet and the equipment is ready
for operation.
Danger!
To rule out danger, this work must be left strictly to a specialist electri-
cian or Customer Service.
6. Operation
GB
You can put the equipment into operation after you have thoroughly
read the installation and operating instructions. Pay attention to the
following points:
•
Check that the discharge line is fitted correctly.
•
Make sure that the electrical connection is 220-240 V~ 50 Hz.
•
Check that the electrical socket-outlet is in good working order.
•
Make sure that no moisture or water can ever reach the power
connection.
•
Lower the pump into the well or shaft using the securing cable.
•
Ensure that the pump is completely under the surface of the water
and approx. 20 cm above the bottom.
•
Make sure that the equipment does not run dry.
•
To switch off the equipment, pull the power plug out of the socket
Anl_PE_TP_1000_N_SPK7.indb 114 Anl_PE_TP_1000_N_SPK7.indb 114
- 114 -
19.05.2023 08:55:00 19.05.2023 08:55:00