Pattfield Ergo Tools PE-TP 1000 N Traduction De La Notice Originale page 113

5. Before starting the equipment
Before you connect the equipment to the mains supply make sure
that the data on the rating plate are identical to the mains data.
5.1 Installation
The equipment can be installed either:
•
Stationary with a rigid pipe line
or
•
Stationary with a flexible hose line
•
Connect the pressure hose or pipe to the pressure connector (1)
using a suitable connector.
•
Fasten the securing cable (4) to the suspension eyelet (Fig. 1/Item
2).
Notice!
Before you use the pump, clarify any possible special conditions
which need to be fulfi lled for the installation!
For example, additional safety measures may be needed if damage
to property could result from a power failure, soiling or a defective
gasket.
Examples of such safety measures:
Pumps running in parallel on a separately protected power circuit,
moisture sensors for switching off the pumps, and similar safety ar-
rangements.
Be sure to consult a professional plumber if you have any doubt.
If you use rigid pipe lines, we recommend that you use cable ties to
bind the power cable to the discharge line, with a spacing of approx.
3 m.
Install the pump in such a way that the underside is at least 20 cm
above the bottom, in order to prevent sand, sludge, etc., being drawn
into the pump.
Anl_PE_TP_1000_N_SPK7.indb 113 Anl_PE_TP_1000_N_SPK7.indb 113
- 113 -
GB
19.05.2023 08:54:59 19.05.2023 08:54:59