Eurochron EFW 340 Notice D'emploi page 4

STARTING DCF SIGNAL DETECTION MANUALLY
 
Use this function if, for instance, the automatic summer/winter time conver-
sion was not detected or the radio-controlled alarm clock has not received
the DCF signal for a while.
The previously received DCF data is not deleted and the time resets itself to
the time shown previously, if the signal detection fails.
To perform a manual search for the DCF signal, press the REC button for 3 seconds.
The hands run to the receiving position (12:00) and the radio-controlled alarm clock
tries to detect the DCF signal.
Wait for about 2-5 minutes, until the current time is indicated.
RESETTING THE CLOCK
 
Use this function, if the radio-controlled alarm clock no longer responds to
keystrokes or in the event of other malfunctions.
In this case, all of the previously received DCF data is deleted.
To reset the radio-controlled alarm clock, press the RESET button with a sharp ob-
ject (e.g. a pen).
The hands run to the receiving position (12:00) and the radio-controlled alarm clock
tries to detect the DCF signal.
Wait for about 2-5 minutes, until the current time is indicated.
ALARM FUNCTION
a) Setting the alarm
- The alarm time is indicated on the clock face by a small clock hand.
- Turn the adjustment knob on the case's rear in the direction of the arrow, until
the desired alarm time is shown on the clock face.
 
Only turn the adjustment knob in the direction of the arrow; otherwise, the
alarm time will not be displayed correctly.
b) Activating / deactivating the alarm function
Move the sliding switch on the back of the case to the desired position:
ON Alarm function is activated
OFF Alarm function is deactivated
c) Stopping the alarm signal & snooze function
A crescendo alarm sounds at the set alarm time. This is an alarm sound, the volume
of which increases slowly to allow you to wake up gently.
The signal can be interrupted for approx. 5 minutes by pressing the SNOOZE/LIGHT
button on the top of the case. After this, the signal will restart (snooze function).
To switch the alarm function off, move the sliding switch on the back of the case to
the OFF position.
LIGHTING
Press the SNOOZE/LIGHT button on the top of the case to turn on the clock face
light for a few seconds.
LOCATION FOR USE
Select an level, fl at and stable location for use. Protect valuable furniture
surfaces by using an appropriate underlay; otherwise, it may cause scratches.
Set up the radio-controlled alarm clock so it cannot fall down.
To ensure correct DCF reception, the radio-controlled alarm clock should not be
placed next to electronic devices, cables, metal parts, etc.
MAINTENANCE AND CLEANING
The product does not require any maintenance and should never be disassembled
for any reason.
Please use a soft, dry, clean cloth for cleaning.
Do not use any chemical cleaning agents, as they can discolour the plastic casing.
DISPOSAL
a) Product
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Please dispose of the product, when it is no longer of use, according to the
current statutory requirements.
Remove any inserted battery and dispose of it separately from the product.
b) Batteries and Rechargeable Batteries
The end user is legally obliged (Battery Regulation) to return used batteries and
rechargeable batteries. Do not dispose of used batteries in the household waste!
Contaminated batteries/rechargeable batteries are labelled with symbols to
indicate that disposal in the domestic waste is forbidden. The symbols for
the relevant heavy metals are: Cd=Cadmium, Hg=Mercury, Pb=Lead (marked
on batteries/rechargeable batteries, e.g. under the rubbish bin symbol
shown to the left).
You can dispose of your used batteries/rechargeable batteries free of
charge at your community's collection point or any place where batteries/
rechargeable batteries are sold!
You thereby fulfi l your statutory obligations and contribute to the protection of the
environment.
DECLARATION OF CONFORMITY (DOC)
The manufacturer hereby declares that this product conforms to the fundamental
requirements and the other relevant regulations of Directive 1999/5/EC.
 
You can fi nd the Declaration of Conformity for this product at
www.conrad.com.
TECHNICAL DATA
Operating voltage: 1.5 V/DC (AA/mignon battery)
Battery life: approx. 2 years
Dimensions: 110 x 110 x 50 mm
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by
any method, e.g. photocopy, microfi lming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. These ope-
rating instructions represent the technical status at the time of printing. Changes in technology
and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.