Publicité
Les langues disponibles
Les langues disponibles
EN
Burners with two rings flame
This special burner has two separate flame rings to provide
a real full heat regulation from high power to simmering.
To set :
1. Push and turn counter clockwise the knob between HI-LO
main flame ,when the burner is turned on, the main flame
and the Simmer flame will always light and stay on.
2. Setting heat level main flame from HI-LO power.
Simmer setting
Turn counter clockwise the knob on HI-LO simmering
position, the simmer flame setting will use only the centre
flame.
Turn off the burner
Turn the knob clock wise as far as it will go to the off
position.
6
Dual-Stacked Burners with two rings flame
This special burner has two separate flame rings stacked
one above the other.
For low temperature cooking (Simmer) the ring of flame
is very small and is near the base of the burner. When a
higher temperature is needed the upper ring of fire ignites,
producing 2 rings of flame (Power).
To set :
1. Push and turn counter clockwise the knob between HI-
LO main flame, when the burner is turned on, the main
flame and the Simmer flame will always light and stay
on.
Simmer setting
Turn counter clockwise the knob on LO-SIM position, the
simmer flame setting will use only the bottom flame.
Turn off the burner
Turn the knob clock wise as far as it will go to the off position.
Control knob illumination
When a knob is turned away from OFF, it will illuminate
(white). When a burner has been in use and is then turned
off, the knob will illuminate red as a "burner hot" warning.
A red light will emanate for a short period of time from
around control knob indicating it was recently used.
Publicité
