Publicité
INSTRUMENT OPERATION - Switch the instrument on and apply the tip of the
probe to the substance, surface or area to be measured. The probe should be allowed
adequate time to stabilise to the temperature of the item to be measured.
AUTO-OFF - The unit will automatically turn off after
10 minutes to maximise the battery life. This function can be disabled. To disable the
auto off function, switch the unit off, then press and hold the HOLD/LOCK and
ON/OFF buttons at the same time - 'auto off disabled' will scroll across the screen.
Once the unit is switched off it will revert to the auto off function being enabled.
ROTATIONAL DISPLAY - The unit's display will rotate through 90° with each turn so
that it can be used at any angle or either hand. This function can be disabled. Press and
hold the LOCK button for 3 seconds to lock the orientation of the display, 'Loc on' will be
displayed. To enable this function, repeat as before and 'Loc oFF' will be displayed.
SMART BACKLIGHT - The unit incorporates a smart backlight which automatically
switches on when the unit is being used in low light conditions. The backlight will
activate for 10 seconds. Please note the light sensor is incorporated in the 'o' in the
smart thermometer label.
MAX/MIN - Press the MAX/MIN button to display the values. The instrument retains
the max/min values when switched off. To reset, press the MAX/MIN button for
three seconds, 'rst' will be displayed. Please note whilst in the MAX/MIN mode, the
instrument will continue to measure.
HOLD - Press the HOLD button to retain the last temperature measured, HOLD will
be displayed. To continue to measure, press the HOLD button again.
°C/°F - With the unit switched off, press and hold the
ON/OFF button for 5 seconds to change between
°C and °F. Once changed, the unit will remain in the selected value.
BATTERY REPLACEMENT - The low battery symbol will indicate when the
batteries need replacing. The instrument continues to measure accurately but
we recommend that the batteries are changed as soon as possible. To replace the
batteries, remove the battery cover on the bottom using a pozi screwdriver. Replace
the AAA batteries ensuring that polarity is correct. Replace the cover and tighten to
ensure the unit remains waterproof. The cover can only be fitted one way.
Please note: If the batteries are removed, modes set such as Lock and Max/Min will
be reset to the default setting.
INSTRUMENT CLEANING - Clean the instrument regularly with an anti-bacterial
probe wipe to avoid potential food-borne bacteria growth.
WARNING: IPA and other solvents may cause damage to the case and screen of this
instrument.
ERROR MESSAGES - 'Lo' will be displayed if you are measuring below the
instrument's range. 'Hi' will be displayed if you are measuring above the instrument's
range. 'Err' will be displayed if the probe develops a fault. If the error message
remains, contact our service department for further assistance.
FR - INSTRUMENT OPERATION - Allumer l'instrument et appliquer la pointe de la
sonde à la substance, surface ou zone à mesurer. Il faudra laisser suffisamment de
temps à la sonde pour se stabiliser à la température de l'objet à mesurer.
AUTO-OFF - L'unité va automatiquement se mettre hors service après 10 minutes
pour optimiser la durée de vie des piles. Cette fonction peut être désactivée. Pour
désactiver la fonction de mise hors service automatique, éteignez l'unité, puis
appuyez et maintenez simultanément les boutons HOLD/LOCK et ON/OFF - 'auto off
disabled' (mise au service automatique) va défiler à l'écran. Une fois l'unité éteinte,
elle va revenir au réglage par défaut avec la fonction mise hors service automatique
activée.
Publicité
