Orbegozo WF 0242 Manuel D'instructions page 8

WF 0242
ASSEMBLE AND USE
Structure diagram
1.Front Cove
2.Fastener for Fan blade
3.Fan Blade
4.Fastener of Cover
Assemble the back cover (5)
- Attach the back cover (5) to the motor by fastener (4).
- Be careful about the rotation of the fan blade.
- Fix the cover ring to the back cover by placing the channel of the cover ring around the circumference of
the back cover.
-Tight the screw half way to avoid unnecessary movement while assemble the fan blades.
Attach the fan blades (3)
- While installing the fan blades insert the opening on the back of the fan blade inside the spacer pin of the
motor shaft (6) of the motor.
- Fasten the Fastener for Fan blade
Assemble the Front Cover (1)
- Attach the circumference of the front cover (1) inside the other channel of the covering ring.
- Finally tight and secure the screw of the covering ring.
INDICATIONS
- This fan can tilt upwards and downwards by turning and let loose the joint knob (7). It is important to re-
secure this knob after you adjust the settings.
- Using the remote control buttons. Select the function required. The remote control requires
2×AAA batteries.
- To switch on use the remote control power'ON/OFF' (encendido/apagado) button and press the'SPEED'
(velocidad) button to select the airflow required (low, medium, high).
- To oscillate fan, with power on, press the remote control'TURNING (osc)'button.
- The timer can be set from 0.5 hr to 7.5 hrs using the 'TIMER (temporizador)'button on the remote control.
The timer increases in half-hourly increments each time the button is pressed.
- To choose the mode, press the remoe control 'MODE' button. You can change nature, normal or sleep
mode.
SOLUTION TO SIMPLE FAILURE.
- Always check whether the power plug has been inserted properly into the socket
- Always check whether the fan blade is in contact with other parts such as the protective
Covers (1,5).
5.Back Cover
6.Motor shaft
7.Joint
8.Frame
9.Wall Base
10.Holdfast
11.Receiver window
8