Publicité
Les langues disponibles
Les langues disponibles
DO9102W
BATTERY
1 pc of lithium battery 3V CR2032.
Please remove the isolation sheet from the battery contact
before use. Please take note to the polarity.
REPLACING THE BATTERY
Open the battery case cover on the back of the scale.
Lift the battery out of the compartment and place a new battery by
first placing one side against the positive plate and then pressing
down the other side of the battery.
OPERATION
1. Put the scale on a hard and flat surface to guarantee the
accuracy of the scale. Avoid carpet or soft surfaces and make sure that there is
nothing underneath the scale.
2. Gently step on the scale. Put your feet evenly on the scale without moving. The
scale turns on automatically.
3. Wait until your weight shown on the display is stable and locked.
AUTOMATIC SWITCH OFF
When you step off the scale, it will automatically switch off. Auto shut-off occurs
approximately 8 seconds after a stable weight is reached.
OVERLOAD INDICATION
"Err" code indicates scale overload.
LOW BATTERY INDICATION
"Lo" code is shown when battery power is low. Please install new battery.
ERROR DURING WEIGHING
"C" code is shown when an error occurs during weighing. Step back on to the scale to
weigh again.
ADVISE FOR USE AND CARE
Attention: the glass surface is slippery when wet. Keep the surface dry.
•
Keep standing still during the course of weighing.
•
Do not strike, shock or drop the scale.
•
Treat the scale with care as it is a precision instrument.
•
Clean the scale with a damp cloth and avoid water getting inside the scale.
•
Do not use chemical or abrasive cleaners.
•
Keep the scale in a cool place with dry air.
•
Always keep your scale in horizontal position.
18
plaque positive
Publicité
