Publicité
Les langues disponibles
Les langues disponibles
4.2 Charging terminal devices
• Connect the microUSB charging/connecting cable
included to the one of the two USB ports on the Power
Pack (OUT 1 5V/2.1A / OUT 2 5V/2.1A) and to the
microUSB port on your terminal device (mobile phone,
smartphone, etc.).
• The Micro-USB charging/connecting cable included
may not be suitable for the USB connection on your
terminal device. In this case, use the USB cable that
was included with your terminal device.
• To start charging, press the button
Pack. The status LEDs show the remaining capacity
when the Power Pack is charging.
• The current battery status of your terminal device will
appear on this device.
• Press the button
charging and to switch it off. The status LEDs should
switch off.
• The Power Pack will automatically switch off after 10
seconds if it is not connected to a terminal device.
Warning – Connecting terminal devices
• Before connecting a terminal device, check
whether the power output of the charger can
supply sufficient power for the device.
• Ensure that the total power consumption of all
connected terminal devices does not exceed
2100 mA.
• We recommend that you always use just one of the
two USB ports.
• Please refer to the instructions in the operating
manual of your terminal device.
• It is essential that you observe these specifications
and the safety instructions regarding the power
supply of your devices.
of the Power
of the Power Pack to stop
Note – Optimised charging
• Optimised charging means that the Power Pack
recognises the connected terminal device and
supplies it with the optimal current to minimise
charging time. Note that the maximum current
output from the Power Pack is 2100 mA, as long as
NO terminal device is connected in parallel.
• Of course, any brand of terminal device can be
connected to all the USB ports as long as the
maximum current consumption for each is not
exceeded.
Warning
• Never connect the charging cable of the Power
Pack to both the input and the output of the
Power Pack at the same time. This could damage
the battery.
• Do not connect any terminal devices while the
Power Pack is charging. This could damage the
Power Pack and the connected device.
4.3. Torch function
• Press the button
LED torch on/off.
Note
• We recommend that you only use the torch for
brief periods.
• Longer periods of use negatively affect the Power
Pack capacity.
• This product is only intended for use as a torch.
This product is not suitable for lighting rooms in
domestic households. Due to the brightness of
its LED lamp, this product is a special lamp.
5. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
twice to switch the integrated
3
Publicité
