Safety Instructions; Conformity With Standards; Technical Data - Eaton CEAG LG 443 Mode D'emploi

1.

Safety instructions:

For skilled electricians and trained personnel
in accordance with national legislation,
including the relevant standards and, where
applicable, in acc. with IEC 60079-17 on electrical
apparatus for explosive atmospheres.
Observe the national safety rules and regulations for
prevention of accidents as well as the following
safety instructions which are marked with an (
these operating instructions!
- The charger must not be installed in a hazardous
location of zone 1, 2, 21 or 22 accd. to
IEC/EN 60079-10-1 and IEC/EN 60079-10-2!
- The indications on the charger are to be observed!
- Modifications to the charger or changes of its design
are not permitted!
- intended purpose and in perfect condition!
- For replacing components, only genuine Cooper
Crouse-Hinds (CCH)/CEAG spare parts may be used!
- Repairs may only be carried out by CCH/CEAG or a
qualified "electrician"!
- Only the type SEB. lamp may be charged by means
of this charger (also see SEB . operating instruc-
tions)!
- Non-rechargeable batteries (dry batteries) must not
be put in the charger!
- Prior to opening the charger, pull the mains plug!
- Prior to putting the charger into service, check its
correct functioning and perfect condition in
accordance with these operating instructions and
other applicable regulations!
2.

Conformity with standards:

The charger has been designed, manufactured and tested
ac cording to the state of the art and to
DIN EN ISO 9001:2008.
This charger is suitable for use in protected and dry locations.
3.

Technical data

Charger:
Input voltage
Typ LG 443:
Typ LG 443/1:
Power input:
Recharge period:
) in
Permissible ambient
temperatures
(also see SEB. operating
instructions):
during the charging process
Storage in original packing:
Protection category to
EN/IEC 60529:
Insulation class to
EN/IEC 61140:
Geometrical data
of the charger:
Dimensions in mm
(d x w x h):
Weight:
4. Description and application
The charger serves for charging and storing the SEB. portable
lamp (also see SEB. operating instructions).
It is fitted with an apx. 1.5 m long mains connecting lead with
mains plug. On the back of the charger there are three drilled
holes which can be used for fastening the charger (see
attached drilling template).
Charging the lamps:
The lamps may be charged outside of hazardous areas
only!
Put the lamp in the charger from above, with the light aperture
to the front, and press it down.
As to the charging function and charging process, see the
operating instructions of the lamp on charge.
Subject to alteration or supplement of the product series.
Dimensions in mm
LG 443/ LG 443/1
220-250V 50/60Hz
108-132V/60Hz
14 VA
See operating instructions
SEB.
0°C to +30°C
-40°C to +60°C
IP 31
II
163,5 x 151 x 111
appox. 1.25 kg
3