Publicité
Les langues disponibles
Les langues disponibles
12
English
Charging in the charging stand (specific models only)
'Unplug for use' symbol
How do I use my appliance and the attachments?
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.
Make sure the appliance is switched off.
1
2 Put the small plug in the charging stand and put
the supply unit in the wall socket.
3 Place the appliance in the charging stand.
Specific models only: The light ring on the bottom
of the charging stand lights up and rotates quickly.
- After approximately 5 minutes, the light ring
rotates slower. The battery now contains
enough energy for one full shave.
- As the appliance continues to charge, the light
ring becomes brighter and rotates slower.
- When the appliance is fully charged, the light
ring lights up fully and stops rotating.
4 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
charging stand.
The 'unplug for use' symbol flashes to remind you to
disconnect the appliance from the wall socket and
remove the small plug from the appliance before you
switch it on.
Warning: Always check the appliance and all
accessories before use. Do not use the appliance
or any accessory if it is damaged, as this may
cause injury. Always replace a damaged part with
one of the original type.
Note: This appliance is waterproof. It is suitable for use
in the bath or shower and for cleaning under the tap.
Publicité
