LG DLEX4370 Série Mode D'emploi page 40

40
TROUBLESHOOTING
Before Calling for Service (cont.)
Problem
• Water level error.
Steam does not
generate but
no error code is
shown
• Too many or too different types
Garments still
wrinkled after of garments in dryer.
STEAM FRESH™
• The function of this cycle is to
There are no
creases left on remove wrinkles from fabric.
garment after
STEAM FRESH™
• This is normal.
Garments have
static after
REDUCE STATIC
• Correct drying options not
Garments are
too damp or too selected.
dry after REDUCE
STATIC
• This is normal.
Water drips from
door during
Steam Cycle
• This is normal.
Steam is not
visible during
Steam Cycle
• This is normal.
Drum does not
turn during
Steam Cycle
• This is normal.
Cannot see
steam vapor at
the beginning of
cycle
• MORE TIME button pressed.
The display
shows
• STEAM FRESH™ did not remove
Odors remain
in clothing after odor completely.
STEAM FRESH™
• Lint filter is almost clogged or
CHECK FILTER
light is on during full.
the drying cycle
• Ductwork is too long or has too
TM
FLOW SENSE
many turns/restrictions.
indicator shows
four bars during
• Significant blockage of the
the drying cycle
ductwork due to lint buildup or
or the display
debris.
shows "d75" after
• The appliance has detected a
drying.
restriction in the external dryer
venting.
• Electric dryer power cord is not
Display show
error code nP connected correctly, or house
power supply is incorrect.
Possible Causes
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting REDUCE
STATIC option.
• Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the
inside of the dryer door if the steam system is operating
normally.
• The drum is turned off so that the steam vapor remains
in the drum. The drum will normally turn for about 2
seconds once a minute.
• Steam is released at different stages of the cycle for each
option.
• This display indicates that the steam option has been set
for a " " item such as a comforter.
Press the LESS TIME button to reduce the indicated load
size.
• Fabrics containing strong odors should be washed in a
normal cycle.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the Flow Sense
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
ON/OFF button will turn off the display.
• Check the power supply or the connection of the power
cord to the terminal block.
Solutions
TM