Publicité
Les langues disponibles
Les langues disponibles
Trim Kit Installation
Installing Trim Kit Tie Bar
(Dual Installation Only)
NOTE: Leveling may be required to line up the holes
in steps "a" and "d".
5. a. Tie units together by securing the mounting
bracket at the back of the units with a
3/8" socket. (See Figure 5).
b. Install center strip to insure the proper 3/8" gap
is maintained between units. (See Figure 6).
c. Tie units together with the common mounting
bracket at the front top with two screws in
the inner two screw holes by using a 3/8" socket.
(See Figure 7).
d. Tie units together with common mounting
bracket at the bottom front using #3 Phillips
driver. (See Figure 8).
3/8" Gap
Item 2H
Figure 5
3/8" Gap Between Units
3/8" Center Strip
Item 1 Dual kit
Figure 6
Item 1H
Figure 7.
Item 1H
Trim Kit Installation (Single Unit Installation)
6. Remove outer screw from top hinge using a 3/8"
socket driver or wrench and save for later. Install
mounting bracket with one screw mounted to inside
hole using a 3/8" socket. (See Figure 9).
3H
Side Trim Installation
(Single and Dual Installations)
7. a. Position Left Hand Side Trim on cabinet trim with
bottom resting on the floor.
b. Drill the 1/8" (3mm) pilot hole.
c. Run screw in all the way and then back out.
Remove side trim for later install. (See Figure 10).
NOTE: Some cabinet substrates may require pre-
drilling holes using a 1/8" (3 mm) diameter drill bit.
©2013 Electrolux Home Products, Inc.
Get other manuals https://www.bkmanuals.com
INSTRUCTION SHEET
Figure 8
Remove Screw
Figure 9
Instruction Sheet A00343901
11.04.13
Publicité
