Publicité
AC AND DC CABLE INSTALLATION
INSTALLATION OF THE AC POWER CABLE TO THE POWER SUPPLY
All AC power cables use a push-lock type M19 3-pin connector to connect the cable to the power supply. The connection to power is available in several
plug types for receptacles, or in pigtails for direct wiring
To Attach or Remove the Connectors:
1
To install the connector, match up the keyed
pins on the cable (male to female) to the
receptacle and push it on until you hear a
"click" Check that the connector is securely
attached by lightly tugging on the cable The
cable will not come off if properly installed
Failure to test the cable connection may result
in electrical shock or damage to the product
2
To remove the connector, twist the ring on
the base of the connector counter-clockwise
approximately a quarter turn until it stops to
release, and then pull straight out
1
"CLICK"
2a
2b
7
Publicité
