Publicité
IMPORTANT SAFETY PRECAUTIONS
•
The system should only be cleaned as directed in the Fluence's Fixture
Cleaning Recommendations which can be downloaded from the Fluence
Support Center www.fluence.science/support-center/.
•
You should seek service for your system by qualified service personnel if any
of the following occur:
1 The power-supply cord or the plug has been damaged
2 The unit has been exposed to rain
3 The unit exhibits a marked change in performance
4 The unit has been dropped, or its enclosure or chassis is damaged
CULTIVATION BEST PRACTICES
Fluence encourages everyone to experiment and pursue their own techniques
Every crop is different and everyone has different goals However, our internal
research has given us insight into several strategies we would like to share
•
Regularly check your plants' growth and health Fluence lighting systems
deliver high levels of PAR, typically more than experienced in nature
Adjustments to H2O, CO2, RH, nutrients, and temperature are typically required
•
Mount the fixture at least 6" from the top of your canopy to ensure optimal
uniformity and consistent PPFD The SPYDR Series was designed to provide
uniform light dispersion and requires precise deployment A 1" variation in
either direction will have a significant change in uniformity and PPFD (which
may or may not be desired)
•
Many plants prefer higher temperatures when exposed to high PPFD
Experiment with higher temperatures to achieve higher yields Canopy
temperature and room ambient temperature often vary For accurate results,
test at the canopy level to gauge leaf surface temperature
For cultivation recommendations visit
www.fluence.science/science-articles/.
4
4
GENERAL CARE
SPYDR Fang system is passively cooled with zero moving components
They are designed for accepted horticulture environments and years of
maintenance-free performance Some basic care will keep your system
operating at peak performance cycle-after-cycle
•
Natural convection removes heat away from the heatsink In order for
the system to properly cool itself, at least one inch of space is required
between the console and the roof of your grow area Failure to do so may
shorten the fixture's lifespan
•
To achieve the optimal lifespan and performance of your fixtures, routinely
check for and remove excess dust, debris, and mineral build up from
heatsink and LED array Cleaning should always be done with the fixture
unplugged from its power source using low-pressure compressed air or
water to rinse away dirt from light bars
•
Never use a cloth to clean the diode array Doing so can scratch or
compromise the integrity of the silicon seal, or dislodge diodes entirely
•
To limit degradation, avoid touching the diodes with your hands, even in a
powered off state
For detailed instructions for maintenance and cleaning,
please visit
www.fluence.science/support-center/.
SPYDR Fang is a high-performance lighting
system. Do not touch while in operation.
Last and most important, please recycle all
packaging material.
Future generations will thank you.
Publicité
