Publicité
AC AND DC CABLE INSTALLATION
WARNING: Risk of Electrical Shock Turn off and disconnect the power before installing, moving, or cleaning to reduce the possibility of
serious injury DO NOT connect or disconnect cables to or from the power supply or LED light bar while energized Test all cable connections
for correct and secure engagement after installation
INSTALLATION OF THE DC POWER CABLE TO THE POWER SUPPLY AND LED LIGHT BAR
All DC cables use a push-lock type M19 2-pin connector to connect the cable to the power supply and LED light bar.
To Attach or Remove the Connectors:
1
To attach the connector, match up the keyed
pins on the cable (male to female) to the
receptacle and push it on until you hear a
"click" Check that the connector is securely
attached by lightly tugging on the cable The
cable will not come off if properly installed
Failure to test the cable connection may result
in electrical shock or damage to the product
2
To remove the connector, twist the ring on
the base of the connector counter-clockwise
approximately a quarter turn until it stops to
release, and then pull straight out
6
1
"CLICK"
2a
2b
Publicité
