Publicité
Les langues disponibles
Les langues disponibles
EN
INSTALLATION AND COMMISSIONING
GLOBAL PARAMETERS CONFIGURATION
Once that local parameters are set, the global parameters must be configured to ensure an optimum performance of
the device. Consult the instruction manuals of the monitoring system for further information.
PAIRING WITH A U·VISION DEVICE (383500, 383501)
This device is equipped with a wireless connection so that it can be paired with a U·vision or U·vision
Consult the U·vision instruction manual for further information.
INDICATOR LEDS AND DIAGNOSIS FUNCTIONS
INDICATOR LEDS
While the device is in standby mode (the device is online but not dispensing fluid), the following parameters can
be checked:
• Press and hold F1 button to show the installed firmware version in the display.
• Press and hold F2 button to show the power supply voltage (in volts).
6
838 844 R. 05/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
INDICATOR
STATUS
ONLINE LED
Blinks there times U·vision device paired.
E.O.L. LED
S.V. ON LED
Blinking
BY-PASS LED
Blinking
DISPLAY
DISPLAY
DISPLAY
* Only U·valve + model.
Off
CAN cable not connected or CAN BUS ERROR.
On
CAN cable correctly connected.
Off
Not configured as end of line.
On
Device configured as end of line.
Off
Solenoid valve closed.
On
Solenoid valve open.
Malfunction of the solenoid valve.
Off
By-pass mode off.
On
By-pass mode activated.
Malfunction of the solenoid valve.
Wifi connectivity not available*.
C
Wifi configuration mode*.
"C" Blinking indicates that wifi configuration is
"C"
being transmitted to the device*.
+
gun.
INDICATION
Publicité
