Publicité
Les langues disponibles
Les langues disponibles
Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable
mat or a record's edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record
cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol,benzene or any other harsh
chemicals, with might damage the paint and finish of the turntable.
Troubleshooting
There is no power
· Power adaptor is not connected correctly.
· No power at the power outlet.
Power is on, but the platter does not turn
· This unit is not in turntable mode. Press the MODE button to turntable mode, the
indicator light in red.
· Need to press the PLAY / STOP button once to start playing.
· Turntable's drive belt is not installed or has slipped off.
Turntable is spinning, but there is no sound, or sound not loud enough
· Stylus protector is still on.
· Tone arm is lift up by the lever.
· The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo
system's line input.
· Forget to connect the speaker to the turntable.
Record sounds too fast or too slow
· Wrong speed selected for the record.
Strong hum on phono input
· The cable is not grounded correctly.
Remark:
To protect the stylus, the platter will Stop automatically if no music has been playing for 3 min.
For lowering the power consumption, the whole unit will switch to standby mode
automatically if no music has been playing for about 15 minutes.
If your unit switches off regularly, this is
To restart the unit, hold press the "MODE" Button.
no defect.
EN - 25 -
Publicité
