SOGETRONIC VISION 2 SET WLD Manuel D'utilisation page 25

Maintenance and Cleaning
Your turntable requires little of no regular maintenance. Remove dust with a slightly damp
antistatic cloth. Never use a dry cloth, this will create static electricity and attract more dust!
Antistatic cleaning agents are available at specialist stores, but must be applied sparingly to
avoid damage to rubber parts. It is recommended to install the needle cover before cleaning or
maintenance is carried out to avoid damage.
If the turntable is not used over a long period of time, the drive belt should be removed to
prevent unequal stretching.
NOTE: Always disconnect the record player from the power supply as a precaution before
maintenance!
Useful Tips
The turntable should be positioned on a low-resonance surface such as wood or multiple layer
ply board to avoid structural vibrations disturbing playback.
Cartridge Replacement
6. Before replacement, put the stylus protector back on the stylus to prevent damage to
the stylus during the replacement process.
7. Carefully remove the wire leads from the original cartridge.
8. Loosen the two screws on the headshell that are securing the cartridge and then
remove the original cartridge.
9. Mount the new cartridge to the headshell and tighten it lightly. Do not completely
tighten the screws at this moment.
10. Connect the wire leads to the new cartridge's terminals. The wire lead color are as
below:
White
Black
Red
Black
11. Adjust the cartridge's position to make sure it is precisely aligned on the headshell so
that the stylus will be tracking the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the
turntable spindle, carefully lift the tone arm and place the tip of the stylus on the points
marked 130mm and 250mm respectively. Fine tune the cartridge's position on the
headshell until the cartridge is perfectly in parallel with the reference lines at both posits.
12. Tighten the screws completely once the perfect alignment is achieved.
Left channel positive
Left channel negative
Right channel positive
Right channel negative
EN - 23 -
(L+)
(L-)
(R+)
(R-)