SOGETRONIC VISION 2 SET WLD Manuel D'utilisation page 20

The anti-skating force must be adjusted corresponding to the down force as follows:
Down force
5 - 10mN
10 - 15mN
15 - 20mN
20mN and bigger
Stereo System Connection
RCA Jacks
· The RCA Jacks of this unit are shared as both the Phone output jacks and the Line
output jacks. They are determined by the Phono/Line Switch.
· When used as a line output, the jacks output analog line-level signals and could be
connected directly with a pair of active speakers or the appropriate input of your stereo
system. When used as a Phono output, they should be connected to the phono
pre-amplifier or the phono input of the stereo system.
· The Red plug connects with the Right channel and the White plug connects with the Left
channel.
Note:
· If the Phono/Line switch is set at LINE position but RCA jacks connected to the stereo
system's phono input, the sound might be distorted due to input overload and could
damage your stereo system.
· If the Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo
system's line input, the volume will be very low due to lacking signal pre-amplification.
RCA Jack is not designed to be connected directly to the passive/unpowered speakers
and if it does, the volume will be very low.
Speaker Connection
The spring clip speaker terminals deliver amplified, speaker-level signals as output and
should be connected with the passive speakers.
Bluetooth Operation
1. Press the Power Switch to turn on the power.
2. Press the MODE button to choose Bluetooth mode, the indicator will light in blue. You
will hear an activation sound from the unit.
Turn on the Bluetooth feature of your audio device, search for "VISION 2 SET" and pair.
3. Once your device is successfully paired with the unit, you will hear a short confirmation
sound from the unit.
4. Play and stream music from your device to the unit.
Note: Bluetooth version - 4.2
Turntable Operation
1. Press the Power Switch to turn on the power.
2. Press the MODE button to choose turntable mode, the indicator will light in red.
3. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
Groove in the stub
1 st from bearing rings
2 nd " " "
3rd " " "
4 th" " "
EN - 18 -