Quick HRC 1002 C00 Manuel D'installation Et D'emploi page 16

INSTALLATION - OPERATING
EN
PERSONALIZING THE CONTROL PANEL
In some HRC models the symbols on the individual keys can be changed by applying the stickers provided. The
procedure for personalizing the control panel is as follows:
• Clean the relevant surfaces with a soft cloth dampened with water (fig. 1).
• Choose a sticker for application to the surface cleaned previously.
• Centre the sticker on the surface without applying pressure and then press it down on the surface for 5 seconds.
FIG.1
WARNING: the application of adhesives is not recommended if the temperature of the surface of the control
panel is below 10°C.
CONNECTING THE CONTROL PANEL TO THE SOCKET
Connecting
After installing the socket as described above, proceed as follows:
• Rotate the ring-nut of the protective cover anticlockwise until screw off and remove.
• Insert the instrument plug into the relevant socket, taking care that the position of insertion is correct.
• Turn the plug locking ring-nut clockwise until fully closed.
Disconnecting
• Turn the plug locking ring-nut anticlockwise until fully open and remove.
• Cover the socket with the cover provided and turn the ring-nut clockwise until it is fully tightened.
WARNING: always ensure that the socket is closed with the cover provided when the instrument is
disconnected.
WIRING DIAGRAM
BROWN COMMON
1 2 3
1 2
BLUE BLACK
4
3 4
WHITE GREEN
5 6
5 6
RED GREY
5"
7 8
7 8
ORANGE YELLOW
HRC - REV005C