Bosch KSW Série Mode D'emploi page 34

en
Fault
The light does not function.
Bottom of the refrigerator
compartment is wet.
The temperature in the
refrigerator compartment is
too cold.
The refrigerating unit is
switching on more frequently
and for longer.
Appliance is not cooling,
temperature display and light
are lit.
Water dispenser is not
functioning.
Water dispenser is not
functioning.
The "lock" and "on/off"
buttons flash.
Water dispenser is not
functioning.
The "lock" button is still lit
even after it has been
pressed for three seconds.
34
Possible cause
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
The condensation channel
or drainage hole are blocked.
Temperature has been set
too low.
Appliance opened
frequently.
The ventilation openings
have been covered.
Showroom mode is
switched on.
Tap turned off.
Filter on the water
connection is dirty.
Water supply is interrupted.
Water pressure too low.
Supply hose is kinked or
crushed. Fig. .
Water has escaped from the
pipe system.
The integrated AquaStop
system has interrupted the
water supply.
Appliance door is not closed. Close appliance door properly.
Remedial action
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Clean the condensation channel
and the drainage hole. See chapter Cleaning
the appliance. Fig. 1
Increase the temperature.
Do not open the appliance unnecessarily.
Remove obstacles.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
Turn the tap on.
Clean the filter.
Inform plumber.
Ensure that the supply hose is installed
correctly.
Turn off the water supply and inform customer
service (see chapter entitled "Alarm function").