WAYTEX OC 500 Mode D'emploi page 26

Operation
Changing the cutting type ant the cutting band
The rotary cutter allows you to make straight or wavy cuts and perforations. (Type
set on delivery: straight cut).
– Turn the rotary knob
perforation.
– Make sure that the rotary knob
of cut on the blade head (see Fig. E, page 27).
– You can now continue the rotary cut as described under „How to cut with the
rotary cutter".
Warning: Changing the cut type to your desired desired is only possible
when the blade head is in the starting position against the fence.
Change the cutting strip
– If you use the rotary cutter often, the cutting strip
you can turn the cutting strip
– Then start by returning the blade head
– Unscrew the guide rail screw with a screwdriver to change the blade head or
cutting strip.
– Then lift the guide rail
You can lift the cutting strip through the cutout in the middle of the base to
remove it (see Fig. F, page 27).
– Turn the cutting strip
– Reassemble the rotary cutter by fi rst inserting the turned cutting strip.
notch below the blade head in the initial position .
– Then insert the guide rail
push it back into its seat. You can now continue cutting. After changing the blade
head or the cutting strip it is absolutely necessary to fi x the screw to the guide
rail with a screwdriver.
– You can now continue cutting.
26
6
to set the type of cut you want: straight cut, wavy cut or
6
is directed to the symbol of the desired type
3
.
4
in the middle to unlock it from the locking devices.
3
to 180° (see Fig. F, page 27).
4
into the locking devices on the opposite sides and
3
may wear out. In this case,
5
to the initial position.
3
into the