WAYTEX OC 500 Mode D'emploi page 24

Operation
1. Remove the 2 in 1 cutter from the packaging.
2. Check the 2-in-1 trimmer or individual parts for damage. If this is the case, do not
use the 2 in 1 cutter. Contact the manufacturer using the service address.
3. Check that the package contains all the components.
Assembly of cutting units
1. To assemble the two cutting units, place the lever cutter on a fl at support.
2. Hold the rotary cutter vertically (90 °) to the lever cutter (see Fig. 1, page 27) and
insert it into the assembly elements a of the lever cutter.
3. Fold the rotary cutter to the left. The cutting units are now ready to operate and
secure.
WARNING !
- Danger of crushing when the cutting units are assembled and folded down in
operating mode !
Dismantling the cutting units
1. To remove the cutting units, lift the rotary cutter until it is vertical (90 °) to the
lever cutter (see Fig. C, page 27) and remove the unit from the cutting elements.
assembly.
Note: cutting units can only be dismantled and / or assembled at an
angle of 90°.
OPERATION
How to cut with the guillotine cutter
1. The lever cutter
lever cutter by its handle. If the handle is locked, release the locking
part before lifting it.
2. Place the material (paper or other) in the correct position under the cut protection.
The measuring scale on the side stop shows you the correct cutting width. Secure
the material to be cut with the paper pressure strip
24
Risk of crushing
7
is located on the right side of the supplied die-cut mat. Lift the
9
8
.
in the lower