WAYTEX OC 500 Mode D'emploi page 25

Recommandation: before making your fi nal cut, make a few test cuts
with the same material.
Note: never cut more than 10 sheets at the same time. (80 g / m² paper)
with the lever cutter.
NOTICE !
Press down fi rmly on the paper pressure strip
position. To cut the paper, now push the lever cutter in one stroke up and down.
WARNING !
Your hands must not be between the blow guard
How to cut with the rotary cutter
1. The rotary cutter
2. Slide the rotating blade with blade head
3. Set the desired type of cut (straight cut, corrugated or perforated) by turning the
6
rotary knob
Recommandation: before making your fi nal cut, make a few test cuts
with the same material.
Warning: With wavy cut and perforation, never cut simultaneously more
than 3 sheets max. (paper of 80 g / m²) and with the straight cut, never
more than 10 sheets max. (80 g / m² paper).
4. Place the product to be cut (paper or other) in the correct position under the
4
guide rail the measuring scale shows you the exact cutting width.
5. To cut the material, move the blade head
pressure along the guide rail (see Fig. E, page 27).
6. If you want to use the rotary cutter separately, disassemble the two units and
proceed as described from.
Warning!
Risk of injury!
2
is located on the left side of the machine.
(see Fig. E, page 27).
8
and fi x the paper in the desired
8
and the lever cutter!
5
up to the stop under the base.
5
by exerting sustained and even
Operation
25