Note
Manual override mode is used for deep-discharging
vehicle batteries (voltage below 2 V). If the voltage of
the vehicle battery is below 2 V, the boost LED (white)
is off [5].
▸ To activate the manual override function, press the manual over-
ride button [6] for 3 seconds.
3 The boost LED [5] starts to flash. The device has switched to
manual override mode.
Powerbank function
▸ Connect an external device such as a smartphone or tablet to
the USB output socket to charge the external device.
Torch function
▸ Press the light mode button [7] to turn on the internal LED light.
▸ The mode is changed every time you press it.
Operating mode:
100% > 50% > 10% > SOS > Flashing > Strobe > Off
▸ Charge the battery immediately after purchase, after each use
and also every 30 days for at least 24 hours.
▸ Protect the device against humidity and moisture.
▸ Clean the device only by using a clean, dry cloth.
▸ Do not use any liquids or chemical cleaning agents.
▸ Check the unit before each use for damage.
Fault
The LED error indicator
(red) [3] lights up
permanently.
The LED error indicator
(red) [3] is flashing;
the polarity is correct.
The vehicle engine will
not start; the polarity is
not correct.
18
Maintenance / Care
Troubleshooting Tips
Cause and remedy
Check the polarity and change this if
necessary.
The device is too hot. Let it cool down.
The voltage of the connected vehicle
battery is below 2 V. Switch off all
vehicle loads and try again, or use
manual overdrive mode.