Please note the following safety notes to avoid malfunctions,
damage or physical injury:
The hand power puller may only be used for pulling freely moving loads,
such as rolling, swimming or sliding loads within the max. pulling capacity
specified in the Technical Data.
Do not use the hand power puller for lifting loads!
Do not overload the hand power puller. Take into account ambient condi-
tions, such as the angle of incline over which the load must be pulled.
Please also consider conditions such as pulling the load from thick mud,
snow or water. The pulling capacity is given as a rolling load on a level
surface.
Any modifications on the hand power puller are not allowed.
Moving persons with the hand power puller is prohibited.
Keep children and uninvolved persons out of the working area. When
moving an object (vehicle, boat, etc.) persons are not allowed to be inside
the vehicle or in the vicinity of it.
Keep the hand power puller out of reach of children. It is not a toy.
Persons with limited physical, sensorial or mental abilities are not allowed to
use the hand power puller, unless they are supervised and briefed for their
safety by a qualified person.
Wear suitable safety gloves when operating the hand power puller,
preferably use leather gloves. Wear suitable clothes. Do not wear
loose clothing or jewellery. Keep hair, clothes and gloves away from
moving parts.
Keep the working area clean and tidy.
Do not work with the hand power puller in an area where an explosion hazard
is present on account of flammable liquids, gases or dusts.
Never attach the hook on vehicle panels, beams, steering components,
drive shafts, or deck clamps! Do not loop the steel cable around the object
and never draw a loop with the hook!
Do not use the hand power puller to move loads which may drop or roll. If
necessary; take precautions to prevent the load from falling over or rolling.
After work do not release the lever before the load is appropriately secured.
Do not use the hand power puller from a motor vehicle with a running engine.
Before using the hand power puller, make sure the cable is in good
condition. Only use suitable lifting tackles for fastening the load. Inspect the
cable for any kinks, knots, breakage or any other damage. If the cable is
kinked or damaged, or if the hook latch is missing resp. if the cable is shak-
All manuals and user guides at all-guides.com
Safety Notes
5