Westfalia 83 65 71 Mode D'emploi page 21

Intended Use
 The puller and tensioner is designed for moving and pulling freely moving
loads (rolling/swimming/sliding) within the limits that are specified in the
technical data. The puller must not be used for moving fixed loads and for
lifting loads.
 The intended use also includes an operation following the operating instruc-
tions. Any use beyond these parameters (different media, applying force) or
any changes (reconstruction, no original accessory) can lead to serious risks
and is regarded as use that is contrary to the intended purpose.
Before first Use
 Remove the puller and tensioner from
the transport case and check all parts
for any damage in transit before first
use.
 Put the upper lever (2) piece onto the
lower lever (3) piece and ensure it
firmly snaps into position.
Using the LED Flashlight
 The flashlight (1) is stored in the upper lever piece (2).
 Turn the flashlight counter clockwise from the upper lever to use it mobile or if
you have to replace the batteries.
 Remove the flashlight head (13) from the flashlight by turning it counter
clockwise and insert two new batteries of the type LR03 (AAA) into the battery
compartment of the flashlight. Pay attention to the proper polarity of the
batteries. The polarity is printed next to the clip (14). Reassemble the flash-
light in reverse order. Replace both batteries with new batteries of the same
type if the light of the flashlight becomes weaker or if it does not shine at all
anymore.
 Press the on/off button (15) to switch on respectively off the flashlight.
All manuals and user guides at all-guides.com
Operation
17